iFlight BLITZ F411 1S AIO | 5A AIO Whoop Board ELRS This is the iFlight BLITZ F411 1S AIO board, with a onboard ELRS RX and a mounted VTX. Designed for your 65mm and 75mm whoop devices. IFlight has not broken the mould with this AIO board, many other boards are available that have a much lower profile and are lighter. But this board is better thought out then many others, where you lose out on compactness you gain on reliability and a stronger overall design. Product Highlights Support BLHeliSuite programmable Built in 2.4G CC2500 Receiver 5A continuous current Super light only 4.8g MCU：STM32F411 Power supply: 1S Gyro: BMI270 Product Information IFLIGHT BLITZ F411 FC ELRS RX Weight: 4.8g (with power cable, VTX, and VTX antenna) Mounting pattern: 25.5*25.5mm/φ3mm （half-hole) FC Firmware: IFLIGHT_BLITZ_F411RX Supported Protocols: ELRS 2.4Ghz BEC output: 5V 500mA Connector: Micro-USB MCU: STM32F411 INA pad: n uart2 Barometer: NO Size: 29*29mm Gyro: BMI270 Blackbox: NO IFLIGHT BLITZ 5A 1S ESC ESC Firmware: O-H-30 BLS 16.8 (BlheliS) / Bluejay Q-H-50 (Bluejay) Signal Support: Dshot, Oneshot, Multishot Current: 5A continuous and peak 6A Current sensor: yes ESC Telemetry: NO Current scale: 400 Input: 1S 50MW VTX Protocol: Smart audio Power: PIT/25/50mW Connector: UFL/IPEX Input voltage: 5V Channels: 48CH In the box 1x iFlight BLITZ F4 V1 Whoop AIO Board – F411 FC 5A 1S ESC 50mW VTX ELRS 2.4Ghz RX 4x M2 Dampers 1x Antenna More Information iFlight Support Page NOTE: F.PORT protocol RX input support, telemetry not supported. NOTE: Please connect the VTX antenna before applying power from any source. Iflight BLITZ F411 1S AIO Pinout Diagram
