HappyModel SuperX HD ELRS V3 12A AIO Flight Controller SuperX HD ELRS 1-2S AIO flight controller built-in 12A esc and UART based elrs receiver for your Digital whoop build. The new board offers some really good features, The biggest and best change being a UART based serial ELRS receiver, giving the user the ability to independently upgrade the ELRS receivers and the flight controllers firmware. Product Highlights Betaflight 4.4.2 firmware ready Firmware target: CRAZYBEEF4DX MCU:STM32F411CEU6 (100MHz, 512K FLASH) Sensor: BMI270 or ICM42688P (SPI connection) Power supply: 1-2S Lipo Lihv battery input (DC 2.8V~8.7V), only support 1s input for this drone Flight controller SuperX HD ELRS Built-in 12A(each) Blheli_S 4in1 ESC Dshot300 read Built-in UART elrs receiver (Default is connected on UART2) Elrs v3.0 ready, support WIFI and pass-through firmware update Bluejay ESC Firmware ready Built-in 5V 1.5A(Max) BEC Built-in voltage detection Built-in currents meter No betaflight analog osd chip Antenna:enamel copper wire Onboard 4in1 ESC Power supply: 1-2S LiPo/LiPo HV Current: 12A continuous peak 15A (3 seconds) Support ESC-Configurator and BLHELI_S Suite configurator Factory firmware: Z-H-30 – Bluejay, 0.19, 48kHz Default protocol: DSHOT300 Onboard UART ExpressLRS 2.4GHz Receiver RF Frequency: 2.4GHz Antenna: enameled copper wire 31mm length Telemetry output Power: <12dBm Receiver protocol: CRSF Default firmware version: ExpressLRS V3.0.1 The same hardware with Happymodel EP1 receiver Could update firmware via ExpressLRS configurator or WIFI or Betaflight pass-through In the box 1 x SuperX HD ELRS 1-2S AIO flight controller 1 x A30 battery connector and cable 4 x Screws and rubber mounting gummies More Information Note: It’s advisable you attempt soldering with quality soldering equipment and have a intermediate level of solder skills. This AIO flight controller does NOT have a onboard OSD chip, if you are building a analogue whoop/toothpick this board may not be your best choice.
