TBS Lucid AIO 1-2S This is the TBS Lucid AIO 1-2S flight controller for your next whoop or toothpick build. The TBS Lucid AIO 1-2S was engineered to tick a lot of boxes for long range 1S/2S drone pilots as well as whoop pilots that don’t enjoy radio link limitations and need a bit of extra power from their stack. Built to a 25×25 “Whoop” form factor, it is the only board that has the necessary grunt to run 2S boards without burning out, while also being capable of running 1S batteries down so low you will hear them beg for mercy. The “AIO” stands for all in one, or a 3-in-1 specifically. Included is an Flight controller, 4in1 ESC and Crossfire Receiver. It also comes with an OSD chip for analog video. It hopefully goes without saying that each TBS Lucid AIO is tested out of the factory and has been put through the wringer by some of the most seasoned whoop pilots before being offered for sale, which further distinguishes the board from some of the incumbents. Product Information MCU AT32F435RMT7, 288MHz Gyro ICM-42688P ESC 4 x 7A (24A total max) with telemetry and current sensor BEC 5V 2A OSD AT7456E Blackbox 8M UARTs 3 (UART1/UART3/UART5) Input 1S-2S Size: 28mm x 28mm (30mm x 30mm outer dimensions) Mounting 25mm*25mm Weight 4g Default/recommended port assignment: UART1: Spare UART2: Smart Audio UART3: DJI O3 Air Unit UART5: CRSF Rx (included on the board) In the box TBS Lucid AIO TBS Crossfire “Micro RX” antenna 4pcs rubber grommets 4pcs motor sockets separate (for plug & play) More Information TBS Lucid AIO Pin out diagram
