Holybro FETtec FC G4 v1.7 The Holybro FETtec FC G4 features the latest STM32 G4 MCU with math accelerator for the ultimate in flight performance, onboard OSD for KISS flight tuning, 2 dedicated BECs for 5V and 16V switchable power, DSHOT2400 outputs for support of up to 8 motors, and dual 20×20 and 30×30 mounting holes. Product Information Latest STM32G4 Processor 180Mhz Math accelerator Gyro IIM-42652 SPI Supply voltage 6-27V (2S-6S Lipo) 2x dedicated onboard BEC (2A each) 5V BEC for RX 5V/16V BEC for VTX (switchable and real Pit*) Improved IO protection All IOs of the microcontroller e.g. in connectors or solder pads are protected against voltage or current spikes 2x 8 pin connector for solder free ESC connection Connector 1: ESC signal 1-4, telemetry, VCC, GND Connector 2: ESC signal 5-8 (depending on UAV type 1-4), telemetry, VCC, GND 1x 8 pin connector for solder free VTX, cam connection and OSD or digital systems real Pit* VCC, GND, Video in, Video out, BEC 5V/16V, VCS/TX3, RX3 2x 6 pin connectors for serials RX1, TX1, 3.3V, VCC, 5V, GND RX3, VCS/TX3, RGB LED, VCC, 5V, GND 1x 4 pin connector for receiver Signal, TLM, 5V, GND 5 UART serials UART 1 free UART 2 used for Receiver UART 3 free UART 4 free UART 5 used for ESCs / TLM / Onewire 4 ESC solder pads (Signal/GND) in each corner Buzzer pads 4 tiny RGB LEDs (selectable color) Supported ESC protocols PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire FETtec Alpha FC firmware (KISS FC firmware flashable) Connector type: JST-SH-1mm *real Pit-Mode: A power supply pin which is remotely switchable PINMAP In the box 1X FETtec KISS FC G4 1X 8 Pin SH1.0 Cable 1X 6 Pin SH1.0 Cable 4X M2 Anti-Vibration Silicone Grommet Insert Manual Holybro FETtec FC G4 v1.7 Manual
